Cambridge Audio Incognito LM10 Installation Manual - page 6
6 Incognito LM10
MOUNTING THE LM10
Locate the LM10 near the local source. Check all connections and test the system’s operation
before installing the LM10 into the wall. Using the included hardware, install the LM10 into a
standard electricians back-box (pattress) (LM10-EU=UK47mm depth single gang, LM10-CU=USA-
type J-box 50mm).
Important
Care should be taken in choosing a site for the LM10, ALWAYS refer to the precautions later in
this guide. Bear in mind that any local sources will likely require mains power.
The LM10 must never be installed in a back-box (pattress) which also contains mains wiring.
The recommended maximum length for use with standard Cat-5 cable is 30m from hub to LM10
to keypad in total. Screened Cat-5 can also be used.
FITTING THE LM10
Note: The LM10 is powered via the Cat-5 cable and no mains connection is required.
The procedure for fitting is as follows:
Remove the supplied faceplate from the LM10 by gently prising apart. It will ‘pop’ off.
Connect each wire in the Cat-5 cable to its respective terminal in the punch-down connector on
the back of the LM10.
Be very careful to follow the colour-code that is indicated on the connector. Always double-check
your connections, and your punching.
Fit the LM10 to the back-box (pattress) that you have fitted in your wall. This is done with the two
supplied screws (LM10-EU=M 3.5mm x 20, LM10-CU=6 x 32 pitch UNC x 6mm Countersunk).
Gently push the faceplate back on to the module.