Cambridge Audio Sonata AR30 User Manual - page 17
Changing tuner region (AR30 only)
The AR30 can also be set to a different region depending on your location. This sets
the correct local de-emphasis and frequency steps. To change the current tuner region,
do the following:
Note:
Make sure that the unit is turned off from the back Power switch.
1. Hold the
Band
button while powering the unit up. The new region will be displayed
when the unit powered up i.e. REGION EU or REGION CU. .
2. The unit will then go to Standby mode and is ready to be used.
3. If necessary, repeat step 1 to choose the correct region.
Setting the source
Press the
Source
button on the front of the unit until the display indicates that the
required input is selected. Alternatively, you may select the desired input directly by
pressing the appropriate button on the remote control.
17
AR30
DR30+
ENGLISH
Adjusting the volume
Use either the
Volume Up/Down
buttons on the remote control, or the
Volume control
on the front of your Sonata system to change the volume level. The newly selected
level will be indicated briefly on the front display.
Adjusting the audio settings
Adjustments to the bass, treble, balance and sub level can be made as follows:
1. To enter the audio menu. Briefly press either the Volume control on the front of the
unit or press and hold the
Menu
button on the remote control.
2. Step through the available settings by either pressing the
Volume control
or the
Menu
button on the remote. Adjustments for bass, treble, balance and sub level
are possible.
3. When you wish to make an adjustment, simply rotate the
Volume control
or use the
Volume control
buttons on the remote control.
4. To exit, press the
Select
button or wait for five seconds, until the unit returns to
normal mode.
The sub level control adjust the relative level of the subwoofer output and main stereo
outputs and can be used to control the sub level for late night listening etc.