Cambridge Audio Sonata AR30 User Manual - page 18
18
Tuning and listening
Select the Tuner source using the
Source
button on the front of the unit or direct
Tuner
button on the remote.
Note:
Before tuning your Sonata AR30/DR30+, make sure that the stereo receiver is
set to 'Manual mode'. Press the
Select/Mode
button on the front of the unit to select
the correct mode.
Sonata AR30
1. In tuner mode press the
Band
button to toggle between AM and FM, and SIRIUS
mode if an optional SIRIUS–Ready module is attached (US version only). See later
section of the manual for SIRIUS tuning instructions.
2. In AM/FM mode, press and hold the
button to scan to previous available stations
or press and hold the
button to scan to the next available stations. 'SCANNING'
will be displayed while scanning for available stations as shown below.
Operating instructions (continued)
3. Short press once the
or
button to fine-tune station frequency.
Sonata DR30+
1. In tuner mode press the
Band
button to toggle between DAB/FM modes.
2. In FM mode, press and hold the
button to scan to previous available stations or
press and hold the
button to scan to the next available stations. 'SCANNING' will
be displayed while scanning for available station as shown previously. Briefly press
the
or
button to fine-tune the station frequency.
3. To perform a complete scan of the DAB broadcasting band, press and hold the
button to enter the scan menu. Rotate the
Volume control
or press the volume
control on the remote to select 'Yes'. Press the
Volume control
or
Select
on the
remote to confirm and proceed with the scan.
Note:
In some regions, the complete scan process can take up to three minutes to
complete.
4. In DAB mode, press the
or
button to browse through the stations currently
stored in the tuner’s database. To select a station, either press
Select
on the remote
control, or
Select/Mode
on the front of the unit. Alternatively, the currently viewed
station will be selected automatically if no button is pressed for five seconds.