CAME MR8106 Installation Tips Manual - page 2
2
OPENING
THE SENSOR
PREPARATION
FOR
MOUNTING
THE SENSOR
60
°
• From behind, before installation
• From the front, after installation
CONNECTING
AND
MOUNTING
THE SENSOR
OTHER
MOUNTING
OPTIONS
• Paste the template
• Drill as instructed
• Insert screws but do not screw them fully home
• If possible, pass the cable where it its supposed to go through
• Run the cable through the orifice
designed for this purpose
• Position the sensor and tighten the
two screws. Make sure you leave
enough cable to reach the terminal
block
1.
This device may be fixed on the
ceiling, so long as the spherical
part of the sensor is facing in the
opposite direction to the door,
and so long as an angular position
of around 60° is chosen for the
antenna.
1 2
12-24 V AC/DC
3
4
COM NO/NC
O
O
O
O
12-24V ac/dc COM
NO
NC