CAME MR8106 Installation Tips Manual - page 6
6
MANUAL
CONFIGURATION
OF
THE SENSOR
+
: press to increase sensitivity
by one unit
–
: press to decrease sensitivity
by one unit
All the sensor parameters not accessible manually are set at the factory values.
These default values may be restored by pressing the two push buttons together for at least two seconds, which resets
everything, including the access code.
The LED flashes for a fews seconds when the unit is started up, and flashed continuously during configuration.
The LED then lights up when the sensor detects motion.
SYMPTOM PROBABLE CAUSE CORRECT ACTION
The door will not open The sensor power is off a. Check the supply
The LED does not light up b. Check the supply voltage
The sensor does not respond to the The batteries have been inserted Check battery insertion
remote control incorrectly
The sensor does not respond to the The access code has been changed Remove the cover and press the 2
code entered with the remote control buttons simultaneously for at least
two seconds.
Then press the unlock button to
begin the configuration process
again.
The door opens and closes constantly The sensor «sees» the motion of a. Increase the tilt angle of the
the door antenna
b. Reduce the sensitivity
If you do not have a remote control, you can adjust the sensitivity parameter only, by means of the push buttons + and -.
LED
SIGNAL
TROUBLESHOOTING