Can-Am DS 450 EFI X mx Operator's Manual - Gearshift Pedal
MAINTENANCE PROCEDURES
CAUTION Never clean radiator
with your hands when it is hot. Let
the radiator cool down before clean-
ing.
NOTICE
Be careful not to damage
the radiator fins when cleaning. Do
not use any object/tool that could
damage the fins. The fins are pur-
posely thin parts to allow efficient
cooling. WHEN HOSING, USE LOW
PRESSURE ONLY, DO NOT USE A
HIGH PRESSURE WASHER.
Radiator Inspection
Inspect radiator and hoses for leaks or
any damage.
See an authorized Can-Am dealer to
check the performance of the cooling
system.
Gearshift Pedal
Gearshift Pedal Adjustment
Remove the screw that clamps the
gearshift pedal on the selector shaft
end, then remove gearshift pedal.
vmo2008-011-019_b
1. Socket screw
Install gearshift pedal at your conve-
nience then tighten screw.
Parking Brake
Parking Brake Adjustment
WARNING
Vehicle must be on a level surface
to perform parking brake adjust-
ment.
Make sure the rear brake components
are in good condition and that the sys-
tem operates properly, then adjust
parking brake as follows:
1. Apply parking brake.
2. Set transmission to neutral.
3. Slide cable adjuster protector to ex-
pose adjuster.
vmo2009-010-102_a
1. Protector
4. Hold adjuster with an open wrench
and loosen lock nut.
100
______________