Can-Am DS 450 EFI X mx Operator's Manual - 12) Ignition Switch
CONTROLS/INSTRUMENT/EQUIPMENTS
When this indicator is ON, it in-
dicates an engine fault code,
look for message at multifunc-
tion display.
When this indicator blinks, it in-
dicates that the LIMP HOME
mode is activated,
refer to
TROUBLESHOOTING
for more
details.
When this indicator is ON, it
indicates that high intensity is
selected on the headlights and
that ignition key is in LIGHTS po-
sition.
When this indicator is blinking,
it indicates the flasher/hazard is
activated.
The proper lamp turns on to in-
dicate the unit the speedometer
uses.
12) Ignition Switch
Key-operated 3 position switch.
vmo2008-018-012_a
IGNITION SWITCH POSITIONS
1. OFF
2. ON “with headlights”
3. ON “without headlights”
NOTE:
The engine stop switch will
override the ignition switch. Make
sure engine stop switch is in RUN po-
sition to allow electrical system activa-
tion.
NOTE:
The taillight turns on both ON
“with headlights” or ON “without
headlights”
Insert key in switch and turn to the de-
sired position.
To remove key, turn key to OFF posi-
tion then pull it out.
The ON without headlights position
turns on the taillight.
The ON with headlights position turns
on the taillight and the headlights.
On both positions, the lights will be on
with either the engine running or not.
Remember that having the lights on
without the engine running discharges
the battery. Always turn the ignition
key to OFF position after engine has
been stopped.
13) Indicator Lamps
vmo2008-018-026_a
1. Low fuel level indicator lamp
2. Neutral (N) indicator lamp
Transmission is in neutral posi-
tion.
Low fuel level. There is ap-
proximately 2.5 L of fuel left in
fuel tank.
_______________
63