Can-Am DS 450 EFI X mx Operator's Manual - page 112
MAINTENANCE PROCEDURES
vmo2008-018-039_a
vmo2008-018-040_a
2. Adjust headlight housing angle by
hand.
3. Adjust both headlights evenly.
4. Tighten screw when proper adjust-
ment is reached.
Headlights Bulbs Replacement
Each headlight has two bulbs, one
headlight bulb and one position lamp
bulb.
NOTICE
Never touch glass portion
of a halogen bulb with bare fingers,
it shortens its operating life. If glass
is touched, clean it with isopropyl al-
cohol which will not leave a film on
the bulb.
NOTE:
Concerning the following il-
lustrations, the headlight housing has
been removed from the vehicle for a
better comprehension.
To replace the headlight bulb, proceed
as follows:
1. Turn the ignition switch to OFF.
2. Remove rubber protector from
headlight housing.
vmo2008-018-038_a
TYPICAL
1. Rubber protector
3. Unplug connector from headlight.
4. Push the retaining clip round ends
forward then set them on the sides
to unlock headlight bulb.
vmo2008-018-036_a
TYPICAL
1. Retaining clip
5. Lift and hold the retaining clip then
remove the bulb.
110
______________