Can-Am DS250 Operator's Manual - 1) Throttle Lever
CONTROLS/INSTRUMENTS/EQUIPMENT
NOTE: This section gives basic func-
tions of the various controls of your
vehicle. For more details of how to op-
erate one control in conjunction with
some others, refer to
OPERATING IN-
STRUCTIONS
further in this section.
1) Throttle Lever
The throttle lever is located on the RH
side of the handlebar.
When pushed, it increases the engine
speed that allows the engagement of
the transmission on the selected gear.
When released, the engine speed
should return automatically to idle and
the vehicle will gradually slow down.
vmo2006-014-008_a
1. Throttle lever
2. To accelerate
3. To decelerate
2) RH Brake Lever
The RH brake lever is located on the RH
side of the handlebar.
When compressed, the front brake
is applied. When released, it should
automatically return to its original po-
sition. Braking effect is proportional
to the force applied on the lever and to
the type and condition of the terrain.
V06K0YY
1
2
TYPICAL
1. Brake lever
2. To apply brake
3) LH Brake Lever
The LH brake lever is located on the LH
side of the handlebar.
When compressed, the rear brake is
applied. When released, it should au-
tomatically return to its original posi-
tion. Braking effect is proportional to
the force applied on the lever and to
the type and condition of the terrain.
vmo2006-014-053_a
TYPICAL
1. Brake lever
2. To apply brake
_______________
57