Conlan CT1000 User Manual - page 6
6
4.3 Changing the Service Code
The Service Code is used to cofigure the CT1000’s settings.
To change the Service Code, enter the following:
○
●
○
●
●
○
*
*
○
○
●
○
4.5 LED Indication
CT1000’s 3 LED’s can be adjusted at will.
Put the desired values together (e.g. YELLOW as normal, YELLOW and GREEN as active:
01+10+20 = 31) and key them in under “Key in value”.
Yellow LED
Green LED
Red LED
Normal
01
02
04
Active
10
20
40
To change the LED indication, enter the following:
○
●
○
●
●
○
○
●
○
After you have entered # the next setting can be changed, to leave the programming mode
enter # again or wait 10 seconds.
4.6 Output Time
CT1000 has 2 transistor outputs (yellow (04) and white (03) wire), which both are activivated in
5 seconds (factory default) by correct code, the activation time can be changed.
The values are divided like this: 1 - 100 in seconds (e.g. 5 = 5 seconds, 101 - 199 in minutes
(e.g. 105 = 5 minutes) and 0 is toggle.
To change these settings, enter the following:
○
●
○
●
●
○
○
●
○
After you have entered # the next setting can be changed, to leave the programming mode
enter # again or wait 10 seconds.
#
Key in the
Service Code
#
Key in
01
#
Key in a new
code
#
Repeat new
code
#
Key in the
Service Code
#
Key in
02
#
Key in value
#
Key in the
Service Code
#
Key in
03 / 04
#
Key in value