Connect Tech Xtreme/10G User Manual - Revision History
Xtreme/10G Managed Ethernet Switch/Router
Users Guide
www.connecttech.com
Document: CTIM-00472
Revision: 0.04
Page 6 of 24
Connect Tech Inc. 800-426-8979 | 519-836-1291
Date: 2017-07-27
ESD Warning
Electronic components and circuits are sensitive to
ElectroStatic Discharge (ESD). When handling any circuit
board assemblies including Connect Tech carrier
assemblies, it is recommended that ESD safety
precautions be observed. ESD safe best practices include,
but are not limited to:
• Leaving circuit boards in their antistatic packaging
until they are ready to be installed.
• Using a grounded wrist strap when handling circuit
boards, at a minimum you should touch a grounded
metal object to dissipate any static charge that may be
present on you.
• Only handling circuit boards in ESD safe areas, which
may include ESD floor and table mats, wrist strap
stations and ESD safe lab coats.
• Avoiding handling circuit boards in carpeted areas.
• Try to handle the board by the edges, avoiding contact
with components.
Revision History
Revision
Date
Changes
0.00
2016-06-15
Never Released
0.01
2016-08-18
Initial Release
0.02
2017-05-30
Updated B2B Connector Pinout Table
0.03
2017-07-25
-
Corrected pin definitions of D69 and D68 in the B2B
Pinout Table
-
Added additional information on breakout board options
and their corresponding reference design package.
0.04
2017-07-27
-
Vitesse Firmware version change, default IP now set to
10.10.10.1