Connect Tech Xtreme/10G User Manual - Introduction
Xtreme/10G Managed Ethernet Switch/Router
Users Guide
www.connecttech.com
Document: CTIM-00472
Revision: 0.04
Page 7 of 24
Connect Tech Inc. 800-426-8979 | 519-836-1291
Date: 2017-07-27
Introduction
Connect Tech’s Xtreme/10G Managed Ethernet Switch (XDG201) provides high density, high port count Layer 2
switching and Layer 3 routing with 10G uplinks. A total of 36 switchable ports, with 4 x 10G, 8 x 1G (SGMII) and
24 x 1G (Copper 10/100/1000Mbps) Ports in an extremely small form factor 85mm x 85mm. The devices target
managed Layer 2 and Layer 3 equipment in SMB, SME, and industrial applications where high port count 1G
switching with 10G aggregation/uplinks are required.
The XDG201 is a Network Switching Module. This module is of a proprietary form factor and contains a board-
to-board connector that allows it to be integrated into an off the shelf carrier like the XBG301 or other
custom/application specific carrier.
Product Features and Specifications
Feature
Description
Ethernet Switch Engine
Vitesse VSC7448 Carrier Grade Ethernet Switch Chipset
Ports
36 Total Switching Ports
4 x 10G (SFI) Ports
8 x 1G (SGMII) Ports
24 x 1G (Copper 10/100/1000Mbps) Ports
Note: All ports are exposed over the proprietary module board-to-board connector; physical
interface must be implemented on carrier board.
Memories
4Gb DDR3 SDRAM
128Mb Serial NOR Flash
I/O Connectors
High-Density 440-pin Board-to-Board Connector
Layer 2 & Layer 3 Forwarding
IEEE802.1Q switch with 4K VLANs and 32K MAC table entries
Push/pop up to 3VLAN tags on ingress and egress
RSTP and MSTP support
Fully non-blocking wire-speed switching performance for all frame sizes
IPv4/IPv6 unicast and multicast Layer 2 switching
with up to 32K groups and 1K port masks
IPv4/IPv6 unicast and multicast Layer 3 forwarding (routing)
with reverse path forwarding (RPF) support
IGMPv2, IGMPv3, MLDv1, and MLDv2 support
Link aggregation (IEEE 802.3ad)
Independent and shared VLAN learning (IVL, SVL)
Jumbo frame support
Quality of Service
Four megabytes of integrated shared packet memory
Eight QoS classes with a pool of up to 32K queues
TCAM-based classification with pat tern matching against Layer 2 through Layer 4
Information
Dual- rate policers selected by VCAP IS2, eight single- rate priority policers per port,
and four single-rate port policers for each port
Flexible 4K ingress QoS mappings and 8K egress QoS mappings for VLAN tags and
DSCP values
Up to 4K egress VLAN tag operat ions
Audio/ video bridging (AVB) with support for time-synchronized, low- latency
and video streaming services
Priority-based f low control (PFC) ( IEEE 802.1Qbb)
Security
Vitesse Content Aware Processor (VCAP™) packet filtering engine using ACLs for ingress
and egress packet inspection
Storm controllers for flooded broadcast, flooded multicast , and flooded unicast traffic
Per-port, per-address registration for copying/redirecting/discarding
32 VCAP single-rate policers
Maximum Bandwidth
80Gbps
Layer 2 Switching Parameters
Packet Buffer:
32Mb
MAC Table Size:
32k
Layer 2 Multicast Port Masks:
1k
Super VCAP blocks:
8
VCAP CLM entries:
4k
VCAP LPM entries:
4k/1k (IPv4/IPv6)
VCAP IS2 entries:
4k/1k (IPv4/IPv6)