D-Link DES-1228/ME User Manual - Dhcp Local Relay Settings
DES-1228/ME Layer 2 Fast Ethernet Managed Switch
35
DHCP/BOOTP Relay Interface Settings
This window allows the user to set up a server, by IP address, for relaying DHCP/BOOTP information to the Switch. The user
may enter a previously configured IP interface on the Switch that will be connected directly to the DHCP/BOOTP server using the
following window. Properly configured settings will be displayed in the BOOTP Relay Table at the bottom of the following
window, once the user clicks the Add button under the Apply heading. The user may add up to four server IPs per IP interface on
the Switch. Entries may be deleted by clicking it’s corresponding
. To enable and configure DHCP/BOOTP Relay Interface
Settings on the Switch, click Administration > DHCP/BOOTP Relay > DHCP/BOOTP Relay Interface Settings:
Figure 6- 7. DHCP/BOOTP Relay Interface Settings and DHCP/BOOTP Relay Interface Table window
The following parameters may be configured or viewed.
Parameter Description
Interface
The IP interface on the Switch that will be connected directly to the Server.
Server IP
Enter the IP address of the DHCP/BOOTP server. Up to four server IPs can be configured
per IP Interface
DHCP Local Relay Settings
The DHCP Local Relay Settings are used on request packets from the Client to the Server. As a result of the customer’s
networking environment, DCHP Local Relay is implemented so that it is independent from the original behavior of DHCP relay.
The DHCP Local Relay is also independent from the option82 module in the forwarding way and the content of DHCP request
packets from Client to Server.
To enable and configure DHCP Local Relay Global Settings on the Switch, click Administration > DHCP/BOOTP Relay >
DHCP Local Relay Settings: