D-Link DGS-3224TGR - Switch User Manual - Basic Switch Setup
DGS-3224TGR Gigabit Ethernet Switch User’s Guide
Basic Switch Setup
Figure 6- 2. Basic Switch Setup window
This window is used to enter name, location, and contact information, as well as to determine whether
the switch should get its IP Address settings from the user (Manual), a BOOTP server, or a DHCP server.
If you are not using either BOOTP or DHCP, enter the IP Address, Subnet Mask, and Default Gateway
of the switch. If you enable BOOTP, you do not need to configure any IP parameters because a BOOTP
server automatically assigns IP configuration parameters to the switch. If you enable DHCP, a Dynamic
Host Configuration Protocol request will be sent when the switch is powered up. Once you have
selected a setting under Get IP From, click Apply to activate the new settings.
The information is described as follows:
Parameter
Description
Get IP From
There are three choices for how the
switch receives its IP Address
settings: Manual, BOOTP, and DHCP.
IP Address
The host address for the device on
the TCP/IP network.
34