D-Link DSL-300G+ User Manual - page 16

DSL-300G ADSL Modem User’s Guide 

Configuring IP Settings 

Follow these instructions to configure the IP settings for the operating system installed on your computer.  

Important: If you are using this Modem to provide Internet access for more than one 

computer, you can use these instructions later to change the IP settings for the other 

computers. However you cannot use the same IP address since every computer must 

have its own IP address that is unique on the local network. 

Windows XP 

1.  In the Windows task bar, click the Start button, and then click Control Panel.  

2.  Double-click the Network Connections icon. 

3.  In the LAN or High-Speed Internet window, right-click on icon corresponding to your network 

interface card (NIC) and select Properties. (This icon may be labeled Local Area Connection). 

4.  The Local Area Connection dialog box displays with a list of currently installed network items. 

5.  Make sure that the check box to the left of the item labeled Internet Protocol TCP/IP is checked, and 

click 

. 

6.  In the Internet Protocol (TCP/IP) Properties dialog box, click the button labeled Use the following IP 

address:  

7.  Type in IP settings as follows, IP address: 10.1.1.10 

8.  and Subnet mask: 255.0.0.0 

9. Click 

 twice to confirm your changes, and close the Control Panel. 

Windows 2000 

First, check for the IP protocol and, if necessary, install it: 

1.  In the Windows task bar, click the Start button, point to Settings, and then click Control Panel. 

2.  Double-click the Network and Dial-up Connections icon. 

3.  In the Network and Dial-up Connections window, right-click the Local Area Connection icon, and then 

select Properties. 

4.  The Local Area Connection Properties dialog box displays with a list of currently installed network 

components. If the list includes Internet Protocol (TCP/IP), then the protocol has already been enabled. 

Skip to step 3. 

5.  If Internet Protocol (TCP/IP) does not display as an installed component, click 

. 

6.  In the Select Network Component Type dialog box, select Protocol, and then click 

. 

7. Select 

Internet Protocol (TCP/IP) in the Network Protocols list, and then click 

. 

8.  You may be prompted to install files from your Windows 2000 installation CD or other media. Follow 

the instructions to install the files. 

9. If 

prompted, 

click 

 to restart your computer with the new settings. 

6