D-Link DSL-300G+ User Manual - page 23
DSL-300G ADSL Modem User’s Guide
Commit & Reboot
Figure 6. Commit and Reboot Menu
To save current configuration settings as they have been submitted click the Commit button. A message informs
you when the settings have been successfully committed to memory. You must now reboot the device to put the
settings into effect. Make sure Reboot is selected in the Reboot Mode: pull-down menu and click
.
WARNING!
Do not reboot the device using
the Reset button on the back
panel of the Modem to activate new changes. This button
resets the device settings to the FACTORY default values. Any
custom settings will be lost.
After the Modem has rebooted it will begin to negotiate the ADSL connection for your account. This will
normally take a few seconds. When the ADSL connection has been successfully established, the ADSL Link
LED indicator will light steady green. If the ADSL Link indicator does not light after a minute or so access the
web configuration manager an double check the settings.
Note: Some accounts use PPP connection software for their Internet service
connection.If you have been given a CD with PPP software, install this now as
instructed by your service provider. After the Modem has rebooted it will negotiate the
ADSL connection. For PPP (PPPoE and PPPoA) connections software is installed on
the computer directly connected to the computer. This software is used to verify the
identity of your account and establish a secure Point-to-Point connection to the service
provider’s network infrastructure.
13