D-Link DSL-502T User Manual - Static Routing

DSL-502T ADSL Router User’s Guide 

Static Routing 

Use Static Routing to specify a route used for data traffic within your Ethernet LAN or to route data on the 

WAN. This is used to specify that all packets destined for a particular network or subnet use a predetermined 

gateway. 

Figure 4-11. Static Routing menu 

To add a static route, choose a connection from the pull-down menu and then enter a New Destination IP 

address, subnet Mask, Gateway IP address and Metric value. Click Apply to enter the new static route in the 

table below. The route becomes active immediately upon creation.  

To remove a static route from the table in the bottom half of the window, choose to Delete it from the table and 

click the Apply button. Remember to save the configuration changes. 

46