D-MAX DSC-300Se5 User Manual - page 12
10
Must use AC24V power source, current intensity must be less than 1.5A
and must use a double winding transformer
Alarm output is tangency output of
relay non-load, it can be used up to
AC220/10A by connecting the load.
The switch is automatically turned
on when the sensor works and it is
possible to cancel by using the
controller after a limited time
The sensor
Can be connected maximum 4 channels and the camera
can be moved automatically to the point by preset mode,
if there is any problem
DATA
Can be processed by RS485 or RS422 and use parallel connection to use a large quanity of
cameras. ( Even if it must be used 2-twist paired cable in use of RS422, the terminal port
which was connected with R485 cable port with 1-pair cable when it is not necessary to take
a return data from camera