Dacor ERV36-ER Installation Instructions Manual - page 11
9
Gently slide the vent into the rear of the countertop cut-
5.
out with the electrical access panel toward the front.
Loosely attach the anchoring legs to the studs on the
6.
left and right sides of the raised vent using the provided
keps nuts and washers.
Adjust the anchoring leg height so that the end caps
7.
are gently resting on the counter, then tighten the hex
nuts.
Secure the anchoring legs to the cabinet floor with the
8.
provided wood screws.
Installation Instructions
Put nuts/
washers on
studs
Front of
raised vent
Floor
Top of vent resting
on countertop
Electrical access
panel
Anchor leg
Installing the Blower and Ducts
Install the remote or in-line blower according to the
1.
blower installation instructions.
Install the duct work according to the
2.
Installation
Specifications
. Use sheet metal screws and duct tape
to connect and seal all of the pieces. Support the duct
weight as necessary to ensure sealed joints.
Example of Installation with Rear Exhaust
(Side View)
REMP16
remote blower
Floor
Wall board
Range
ERV configured
for rear exhaust
ERV
Backsplash
Duct work between
ERV and remote
blower
Wiring/conduit that supplies power
from ERV to remote blower (see
Electrical Installation
, page 10)
3 1/4” X 10”
to 10” round
transition and
45
°
adjustable elbow