Dacor ERV36-ER Installation Instructions Manual - page 14
12
Installation Instructions
Verifying Proper Operation
WARNING
Read the raised vent use and care manual complete-
•
ly before operation.
Install all of the front filters prior to operating the
•
raised vent. Refer to the use and care manual for fil-
ter installation instructions.
CAUTION
To prevent damage to the raised vent power cord, route it
away from the surfaces of the range before connecting it.
Make sure the power switch on the top of the raised
1.
vent is in the up position.
Plug the raised vent power plug into the electrical out-
2.
let.
Press the power switch once to raise the vent to its
3.
operating position.
Once in the up position the vent should begin to draw
4.
air. Turn the variable speed control switch in both direc-
tions to verify that the system is operating correctly.
Press the top cap up/down switch once to lower the
5.
vent.
Make sure that the top cap on the raised vent intake
6.
does not catch on the back edge of the cooktop or
range when the intake is lowered. If interference
occurs, adjust the position of the cooktop or range.
Failure to eliminate any interference may result in per-
manent damage to the vent.
If the raised vent is not operational after installation:
Make sure that power is being supplied to the raised
•
vent.
Make sure that power is being supplied to the blower
•
from the raised vent.
See the
•
Before You Call for Service
section of the
use and care manual.
If the vent will not raise properly or makes a scraping
•
sound check for obstructions interfering with the raising
of the unit.
If the raised vent still does not function proper installation
and after performing the above checks, do not attempt to
repair it. Contact Dacor Distinctive Service at (877) 337-
3226. Be sure to have the model and serial numbers avail-
able when you call. See the label on the front of the raised
vent.
Dacor is not responsible for the cost of correcting problems
resulting from a faulty installation.
Installation Checklist
Are the anchor legs extended down to make contact
□
with the floor and tightened into place? Are the anchor
legs fastened to the floor? Is the unit level?
Is the duct work completely installed? Are all joints
□
attached with sheet metal screws and wrapped with
duct tape?
Are both ends of the remote or in-line blower power
□
cable connected (to the raised vent and to the blower
itself?)
Are the vent filters installed according to these instruc-
□
tions?
Is the power cord routed away from the hot surfaces of
□
the range.
Is the unit connected to an electrical outlet that meets
□
the electrical specifications in these instructions?
Has proper operation been verified?
□
Has the warranty been activated on-line or the warranty
□
card been filled out completely and mailed?