Digiwave Diamond 8000P User Manual - page 11
21
20
6.1 Getting Started
ᶀ Manual Scan
⊹ Select a transponder.
⊺ To change a transponder’s information (Frequency, Symbol Rate), use the NUMERIC
buttons.
⊻ To add a new transponder, press the GREEN button.
⊼
To delete a transponder, press the YELLOW button with the cursor next to the
Frequency parameter.
⊽
To search a transponder, set its different parameters and RED button.
ᶀ Package Identifier (PID) Scan
⊹ Select a transponder.
⊺ To change a transponder’s information (Frequency, Symbol Rate), use the NUMERIC
buttons.
⊻ To add a new transponder, press the GREEN button.
⊼
To delete a transponder, press the YELLOW button with the cursor next to the
Frequency parameter.
⊽
To search a transponder, set its different parameters and press
/
You can
search a specific channel of the transponder by setting its PID data (Video, Audio and
PCR).
⍢
⍢
Note : If you cannot access programs after correctly completing a scan procedure,
please contact your seller or your installer.
CH
CH
6.1 Getting Started
ᶀ Blind Scan
⊹ Select the satellite you want to search by pressing
/
buttons on the remote. You
can select more satellites by pressing OK button on the remote.
⊺ Select the options by pressing
/ L@
/
buttons on the remote.
- Symbol Rate : Select FAST / DETAIL / 7.5M Over / 7.5M Under / 3.7M Under
- Polarization : Select ALL / Vertical / Horizontal
- Search Type : Select ALL / FREE / TV
⊻ Press RED button on the remote to begin blind scan of all of the satellite in the satellite
list.
CH
CH
VOL
VOL
VOL
VOL