Digiwave Diamond 8000P User Manual - Trouble Shooting
45
44
Trouble Shooting
There may be various reasons for the abnormal operation of the unit. Therefore, if the unit
does not work properly, check it according to the procedures shown in the table below:
Problem
Possible causes
Remedy
LED on front panel
AC power cord is not
Make sure that power cord is
does not light.
connected.
connected properly into the
power socket.
Make sure power switch is on.
No Picture or sound
The video/audio output of the
Make sure that video/audio
receiver with TV is connected.
cable is connected to the TV.
The aerial is not connected to
Make sure that the aerial is
the receiver.
connected properly to the
receiver.
Menu setting is not done
Make sure that menu setting is
properly.
done properly on each menu.
If you are not sure about
proper menu setting, please
contact your local dealer.
Black-and-white
Your TV mode is different from
Use TV of same mode.
screen
broadcasting mode.
Use the NITSC/PAL converter
connected to the receiver and
TV.
The remote
Battery exhausted.
Change the batteries of remote
controller is not
Remote controller is incorrectly
control.
working.
aimed.
Aim the remote control at the
Receiver correctly.
2) The Status of the Smart Card
⊹ You can access detailed information about the Smart Card using the
/
keys in
the Main Menu to select ‘CA’ and pressing
.
⊺ Proceed with further instructions displayed on the screen to check more detailed
information depending on the Smart Card in use.
⍢
⍢
Note: Further detailed information is not mentioned in this manual since the
information depends on the Smart Card in use.
VOL
VOL
6.7 Conditional Access System