Digiwave Diamond 8000P User Manual - page 13
25
24
6.1 Getting Started
(4) Other Functions of Remote Control
ᶀ Volume Control
⊹ While watching a program, press
/
control the volume.
⊺ You can press the MUTE button to remove the sound of the program: the mute icon
will be displayed. Press the MUTE button again to turn the sound back on.
ᶀ Channel Information
⊹ You can press the INFO button to display the information banner for a few seconds.
⊺ If you then press the INFO button again, a detailed banner will be displayed.
ᶀ TV/ SAT switching
You can press TV/SAT to select the source of the signal to receive:
- TV Mode
: Signal from TV ANT INPUT will be out. (Front will display ‘TV’)
- SAT Mode
: Signal from Satellite will be out. (Front will display the channel number)
ᶀ TV/ RADIO switching
You can press this key to change from a TV channel to a Radio channel or vice versa.
ᶀ RECALL
Press to return to the previous channel.
ᶀ Audio
Press to adjust the subtitle and/or audio status of the current channel:
- Audio Mode
: Select between, Stereo/Mono-Left/Mono-Right
- Audio Track
: Select between tracks available in this program
- Audio Level
: Select between, Low/Medium/High
- Close Caption
: Select between, On/Off
VOL
VOL
6.1 Getting Started
2) Timer
This sub menu allows you to set the on/off time of your receiver.
⊹ This submenu allows you to set on/off times of your receiver. To display the timer menu,
press the RED button while in the guide menu.
⊺ Press
/
to select a timer’s parameter.
⊻ Press
/
to change the parameter.
- Timer No
: Select the timer that you want to modify. (1- 8)
- State
: Select the timer frequency. (off/once/daily/weekly)
- Date
: Press
to display a Calendar pop-up; Select a date
- Start Time
: Input the time for your receiver power-on; use the NUMERIC buttons
- End Time
: Input the time for your receiver power-off; use the NUMERIC buttons
- Channel
: Press
to display a Channel list pop-up; Select a channel
VOL
VOL
CH
CH