E-Collar Technologies Pro Educator Owner's Manual - page 15
IMPORTANT TRAINING TIPS
E-Collars should be used to reinforce commands your dog already knows. It is
not a replacement for basic leash obedience training, but a tool to allow you to
better communicate to your dog. For best results, use the least amount of
stimulation required to get compliance from your dog. A calm and consistent
approach to training will always produce better long term results. It is highly
recommended that aggressive dogs be taken to a professional trainer for
evaluation before e-collar use. There are many different e-collar training
techniques recommended by a variety of professional trainers. We believe you,
the owner of the dog, can best determine the most successful technique for your
dog. YouTube has many videos demonstrating these varying techniques by
simply searching “educator e-collar training” or “remote dog training techniques
with an educator”.
Good luck with your training and feel free to contact us with any questions.
CAUTION: This product is not intended to be used on human beings except for
testing the product at low levels.
WARNING: E-Collar Technologies, Inc. is not responsible for any misuse of this
product and loss and damages as a result of a dog bite. Aggressive dogs should
be evaluated by a professional trainer before e-collar use. It is not uncommon for
aggressive dogs to associate the stimulation with the handler and take action
against the handler. Sometimes dogs put under e-collar pressure during a fight
can exhibit redirected aggression and become more aggressive.
INDICATOR LIGHT AND BATTERY LEVEL ICON
TRANSMITTER INDICATOR LIGHT
When any of the function buttons are pressed the indicator light will turn “red” to signify
activation. The battery level is displayed as an icon on the LCD.
COLLAR RECEIVER INDICATOR LIGHT
Battery Charge level is signified by the
flashing light going from “green” (ready for
use) to “amber” (need to charge soon) and
then to “red” (charge immediately). When
any of the function buttons of the transmitter are pressed, the indicator light on the collar
receiver will flicker “red” indicating a control signal has been successfully received. It is
best not to wait until it is red to charge Lithium Polymer batteries except when doing the
periodic calibration.