E-Collar Technologies Pro Educator Owner's Manual - page 5
CHARGING THE BATTERIES
The collar receiver and transmitter Indicator lights will blink “Green” under normal
operation and will change to “Red” when activated.
The batteries can be recharged whether the battery is fully drained or not,
leaving them on the chargers in a cool dry place is okay. To charge insert the
micro USB into transmitter and charging plug into receiver.
Low Battery Indication
Transmitter: The level of Battery life is displayed on the LCD below circled in red,
charge prior to last bar for best battery longevity.
Receiver: Indicator Light will blink “Red” when recharging is required, for best
battery longevity charge prior to red light, after approximately 30 hours of use.
We recommend you recalibrate your battery every six months by letting them
fully discharge then fully charge them. Avoid allowing the batteries to fully
discharge except when calibrating. Under normal use, it does not damage the
batteries to charge them before they are fully discharged. Keep batteries away
from high heat at all times, leaving them in the sun or hot location will damage
them and require replacement. Replacement batteries can be found on
www.ecollar.com at reasonable prices with free shipping, we purposely made
them easy to change.
Long Term Storage: Do not store fully charged or discharged, store at
approximately 60% of charge and in a cool place, heat will lower the lifespan of
Li Polymer type batteries.
WHERE TO CONNECT THE CHARGER
Transmitter Battery Charging receptacle is
a micro USB found under the reubber
cover as seen below:
Collar Receiver Battery Charging
Receptacle can be found under the rubber
dust cover as seen below:
The indicator light will turn solid red during charge cycle and turn green
when it is fully charged.
Special Note: The indicator light may not turn green after the first
few charges due to the nature of the Li-Polymer batteries
.