E-Collar Technologies Pro Educator Owner's Manual - page 9
Maximum Durations for Stimulation, Vibration, Tone
(1) Continuous Stimulation “C” Mode: 10 Seconds.
(2) Continuous Boosted Stimulation “C+” Mode: 10 Seconds.
(3) Ramp “R” and Ramp Plus “R+” Modes: 10 Seconds
(4) Instant Stimulation “I” Mode: 45
Seconds
(5) Vibration and Tone Modes: 30 Seconds
I Mode and Lock/Unlock Stimulation Level
* How Instant Stimulation “I” Mode Works
1. Assign instant stimulation “I” mode function to one of the control buttons.
IMPORTANT NOTICE: The stimulation dial must be turned to “0” to start the
“I” mode.
2. To start the “I” mode, push the assigned control button. The display will flash
and is ready to begin stimulation.
3. Turning the stimulation will now activate the stimulation at the setting of the
dial and continue for 45 seconds. Returning to “0” will reset the 45 second safety
timer.
4. If you do not rotate the dial for 45 seconds the “I” mode will turn off and the
control button will need to be pushed again.
5. Pushing any of the other control buttons will turn off the “I” mode and
therefore require the “I” mode control button to be pushed again to reactivate it.
6. Again, to exit the Instant Mode, press any control button or wait for 45
seconds. A tone will beep when the “I” mode times out.
7. Should the dog not require stimulation during the 45 seconds and you want
the “I” mode to stay on, periodical turn the dial up to reset the timer, very few
dogs can fell levels 1 and 2. “I” mode is not recommended for sensitive dogs.
Lock and Unlock Stimulation Level
1. Press “P” button for more than 1 sec to enter into Programming Mode.
2. Confirm all the icons are blinking and
is displayed.
3. Assign “M” or “C” function to any of the four control buttons by pressing the
particular control button until “M” or “C” are displayed. (Refer to Button
Assignment Table)
4. Rotate the stimulation dial to the desired level; now push the particular control
button for 1 second until the 1, 2, or 3 icon stops flashing. Solid icon indicates
locked stimulation.
5. Press “P” button to save and exit from the Programming Mode.
6. To unlock the locked stimulation level, repeat above step and confirm by
noticing the 1, 2, or 3 dog icon is flashing.
Special Note: In the multi-dog modes, any of the dogs can be locked or
unlocked independent of the other dogs.
Flashing icons indicated unlocked and solid icons indicate locked.