1. DL manuals
  2. Easiphone
  3. GPS
  4. SOS Tracker with Voice
  5. Quick Start Manual

Easiphone SOS Tracker with Voice Quick Start Manual

Summary of SOS Tracker with Voice

  • Page 1

    ! ! Easiphone sos tracker with voice quick start guide insert micro sim into sim slot • for the first time use, please fully charge the battery for around 8 hours, using the usb charger. • when charging, the red power led will be on (solid). After fully charged, the power led will be off. • insert a...

  • Page 2

    Gsm led -­‐ green connected to gsm network fast flash every 3 seconds connected to gprs network two fast flashes every 3 seconds no gsm connection slow flash every 3 seconds no sim card always on gps led -­‐ blue has gps location fast flash has gsm location 1 second flash has no location slow flash ...

  • Page 3

    Set geo-­‐fence alarm command: gn, y, z, xxxm/km – (send sms with the text e.G. “g1,1,1,100m” from an authorised mobile) whereby: n=geo fence number (from 1 to 3). The user can set up to 3 geo fences. Y=0 means to turn off the function. Y=1 means to turn on the function. Z=1 means to set alarm when ...

  • Page 4

    Set movement alert command: m1, xxxm/km (send sms with the text e.G. “m1,100m” from an authorised mobile) whereby: xxx is the distance from the devices current location (specified as 3 digitals). M means meters, km means kilometres when the device exceeds the defined distance, it will send an sms al...

  • Page 5

    Set vibration alarm command: v1, xxs/m/h – (send sms with the text e.G. “v1,05m” from an authorised mobile) whereby xx defines the time and must be two digital, s means second, m means minute, h means hour. If activated the device will send an sms alarm to all registered phone numbers every for exam...

  • Page 6

    Set cell locate command: cl1 – (send sms with the text e.G. “cl1” from an authorised mobile). The device will reply “cell locate on!”. The device can be tracked by gsm base station tower, if gps signal is not available. ※ to turn off this function, please send “cl0”. Set gps signal lost and recovery...

  • Page 7

    Set smart power saving mode command: ps1 – (send sms with the text “ps1” from an authorised mobile) the device has a built-in motion sensor. With this mode activated , the gsm chip is always on but the gps chip is only activated by motion or an incoming call or sms. ※ to turn off this function, plea...

  • Page 8

    Cautions please comply with the instructions to extend the unit life: 1. Keep the unit dry. Any liquid may destroy or damage the inside circuitry. 2. Don’t use & store the unit in dusty places. 3. Don’t put the unit in overheated or overcooled places. 4. Clean the unit with a piece of dry cloth. Don...