EasyGate Terrier 200 Installation Manual - page 6
6
The system is delivered with the AC transformer and the DC battery male connector
plugs (white). You will need to plug these in to the matching female connector blocks on
the corner of the control board. A clip is fitted to the side of the plug to correctly align
with the female plug side catcher.
WARNING Battery Power: The battery white connector must be fitted the correct way
round (positive red to +positive) or you will short circuit the control board. There are 2 x
12v batteries fitted under the control board. They are connected together in series to
make 24vDC via a black cable with a yellow fuse with positive of one battery to negative
of second battery. The remaining positive and negative terminals go to the control board
as per the photo above.
Tune-in the remotes and wireless keypad to the control board receiver:
1. Power up the control board by connecting the battery terminal and the AC
transformer. You should now see LED no.1 flash red (2 flash bursts every
second).
a. Press the “RF-learn” button in the top left hand corner for 3 seconds until
the blue light goes on. The receiver blue light can be found under the
“receiver board” mounted at 90 degrees at the top of the main control
board. Hint; you may need to drop your head lower than the board to see.
b. Pickup your remote (or keypad) and press the top left button on your
remote “once”. The receiver blue LED will flash 3 times fairly quickly now.
You can program in extra remotes and keypads while the blue light stays
on.
Hint: Wait until blue light turns off to use your remote (approx. another 7-
10 seconds).
You have now successfully tuned your remote and keypad. Repeat this to add more
remotes and wireless keypads. You can program up to 200 devices. For wireless keypad
enter the default code while the blue light is on. You will need to enter each code
individually.
Removing ALL remote and keypad codes from the receiver memory.
Press and hold down the RF-learn button for 10 seconds