Easypix LCD User Manual - 4.0 Getting Ready
4
4.0 Getting Ready
5.0 Buttons & Function
4.1 Turn on / off Camera
Long-press the Power Button (approx. 2 seconds) to turn on the camera.
Long-press the Power Button again to turn off the camera.
4.2 Inserting the battery
1. Power off the camera.
2. Push the battery cover following the arrow to open.
3. Insert the battery.
4. Close the battery cover.
The indication of the battery status.
( ): Battery power is full.
( ): Battery power is half drained.
( ): Battery power is drained. Replace with a new battery.
The battery may run out if kept inside the camera and
not in use for a long time.
o
o
The battery may not work normally under 0 C or over 40 C.
Note: When battery power is drained, you can connect to PC or
Notebook by USB cable for charging. When charging is
completed, the red LED light will be off.
4.3 Insert / Remove a memory card
1. Power off the camera.
2. Open the battery cover.
3. Insert the memory card into the card slot and press
it down until a click sound is heard.
4. Please press the memory card again to get it out once a click
sound happens.
Note: There is no built-in memory available.
4.4 Attaching Wrist Strap
Make sure strap is properly fixed before you take it.
5.1 Shutter Button
Fully press the shutter button to capture an image.
5.2 Tele / Wide Button
Press the Tele Button, the Zoom Bar Indicator
appearing on the top side of the LCD Monitor
will show the current zoom status. The camera
allows maximum 5.0x digital zoom.
5.3 Up / Voice Memo Button
Press the Up Button ( ) to move the cursor to the up tab in menu.
Under Image Shooting Mode, you can press the Voice
Memo Button ( ) to have 10 seconds of voice memo
after you release shutter.
Under Playback Mode, you can press the Voice Memo
Button ( ) to have 10 seconds of voice memo after you
release shutter.
( ) icon will be displayed on the LCD under playback mode.
21
5M