Eberspracher Airtronic D2 Installation Manual - The Fuel System
the fuel system
17
6
A = Max - 5m (Ø 2mm)
B = Max - 6m (Ø 2mm)
A
B
Affix fuel shut off valve to standpipe
!
Caution!
Safety instructions for installing the fuel pipes!
• Only use a sharp blade to cut the plastic / rubber fuel
hoses and pipes. Metal fuel pipes should be cut using
an appropriate pipe cutter.
• Ensure all cuts are free from burrs and the fuel lines
are not crushed or restricted.
• The fuel line from the fuel metering pump to the
heater should be run to give a continuous rise.
• Fuel lines must be secured every 50cm to avoid
damage by vibration.
• Fuel lines must be protected from any mechanical
damage.
• Avoid running the fuel lines where their condition and
longevity may be affected by movement, vibration or
heat.
• Do not secure the fuel lines to any exhaust system.
• Do not position any fuel connection where it could
leak onto electrical connections or hot surfaces.
• Approval must be sought from any engine or boat
manufacturer, before sharing an existing fuel feed.
• The fuel must not be conveyed by gravity or
overpressure in the fuel tank.
• Withdrawal of fuel after the vehicles fuel pump is not
allowed.
!
Danger!
Risk of fire, explosion, poisoning and injuries!
Caution when handling fuel, remember:
• Switch off engine / heater before refuelling or working
on the fuel supply.
• No naked flames when handling fuel.
• Do not smoke.
• Do not inhale fumes.
• Avoid contact with skin.
Figure 11