Ecobee SMART THERMOSTAT Installation Manual - page 16
Furnace Filter
The Furnace Air Filter reminder generates an alert for
cleaning or changing the furnace air filter.
Select this item to turn the reminder on or off, and to select
the reminder interval (in hours or calendar months). This
reminder also displays the date of the last filter change.
Humidity Filter
The Humidity Filter reminder generates an alert for
cleaning or changing the humidity filter. Select this
item to turn the reminder on or off, and to select the
reminder interval (in hours or calendar months). This
reminder also displays the date of the last filter change.
Dehumidifier Filter
Select this item to turn the reminder on or off, and to select
the reminder interval (in hours or calendar months). This
reminder also displays the date of the last filter change.
Ventilator Filter
Select this item to turn the reminder on or off to choose
the reminder interval in run-time hours or calendar months.
You can also check the date of the last filter change.
Note: If a humidifier, dehumidifier or ventilator is not
configured in Accessory Relays, these options will not
be displayed.
uV lamp
Sets the reminder period for cleaning or replacing the
UV lamp. Select this item to turn the reminder on or off
and to set the reminder in calendar months. You can also
check the date of the last lamp change.
Alerts
The Smart Thermostat can generate alerts when the
temperature in the home reaches a pre-programmed
level. This protects the home from damage due to
freezing and/or excessive heat.
This alert, along with your contact information (if you
programmed the information into the system) will be
displayed on the touch screen. If the homeowner enrolls
with www.ecobee.com, this reminder will be e-mailed to
them and will also appear in their personal web portal.
Performing a Hardware Reset
28
Reset All Setting
Selecting this option will reset the entire Smart Thermostat
system back to the original factory default settings.
Performing a Hardware reset
In rare circumstances, static electricity or power surges
may interrupt the operation of the Smart Thermostat or
Equipment Interface, forcing a hardware reset.
Resetting the Smart Thermostat
You can reset the Smart Thermostat by pressing the
hardware reset button, located through an opening in
the top left corner of the thermostat, as shown below.
Pressing the hardware reset button will not alter
programming or configuration options.
Configuring reminder alerts
The Reminders list displays the reminders and alerts
described below. Use the scroll bar at the right of the list
to see all the settings.
HVAC Maintenance
The Maintenance reminder generates an alert telling
the homeowner that regularly scheduled maintenance
is required.
This alert, along with your contact information (if you
programmed the information into the system), will be
displayed on the touch screen. If the homeowner enrolls
with www.ecobee.com, this reminder will be emailed to
them and will also appear in their web portal.
Select this item to turn the reminder on or off, to show
the date of the last service and to set a reminder interval
between 1 and 12 months.
27 Configuring The Smart Thermostat
To configure reminder alerts:
From the Home
Screen, press More.
Press Settings and
select Reminders and
Alerts from the list.
Reset button indicated in solid colour