EcoWater ESM11+ Installation Manual - page 2
5
1
8
3
4
7
2
6
THANK YOU
Thank you for choosing a water softener from EcoWater. With over 80 years’ experience we have manufactured your new
water softener from quality corrosion resistant materials to give you many years of trouble-free softened water. This manual
will guide you through the steps of how to install your unit. Please read it carefully.
An owner manual covering the care of the unit is also available.
Due to continued product enhancement, EcoWater Systems reserve the right to alter the
technical specification of their products at any time.
UNPACKING YOUR WATER SOFTENER
1 Valve Cover and Electronic Faceplate
2 Salt Lid
3 Salt Cabinet
4 Resin Cylinder
5 Brine Well Cover
6 Brine Valve
7 Overflow Connection rear of Brinetank
8 Drain Connection on Control Valve
Please Remember – Only use tablet or pellet salt in your softener!
Notes
1 Serial Number is inside the valve cover.
2 Remove all packaging parts from inside the unit.
3 If you need to remove the valve cover for ease of
installation follow the instructions carefully.
To remove valve cover pull towards you slowly, taking care not to
pull off the wire connections.
Please note that the valve cover is connected to the valve motor,
so cannot be removed fully.
2