EcoWater ESM11+ Installation Manual - page 8
SETTING UP YOUR SOFTENER
Display
LEFT
Button
UP
Button
RIGHT
Button
E.A.S.E.
Port
SELECT
Button
DOWN
Button
Language
1/6
English
Espagñol
Français
Systems units
2/6
English
Metric
Current time
3/6
15:45
Please Remember – Only use tablet or pellet salt in your softener!
Hardness
4/6
150 PPM
Begin by testing your water hardness using the EcoWater test kit provided (instructions on label) with your softener, as follows:-
1. Remove the reagent from the vial.
2. Fill the vial up to the 10ml mark with a sample of hard water.
3. Add one drop of hardness reagent at a time, being sure to mix up the water after each drop. The water sample colour will change from red
to blue. Count the number of drops added.
4. When the colour changes to blue, this provides your indication of your current water hardness. Now use the following calculation:-
ppm (mg/l) = number of drops x 20 (Example: 16 drops x 20 = 320 ppm).
5. Make a note of your current water hardness below.
Step by step guide to identifying your water hardness
The property’s water hardness is
8
SET UP PROCEDURE
When the EcoWater ESM+ softener is plugged in for the first time, a beep
will sound and the display briefly shows the EcoWater logo, followed
by product information.
Next, six setup screens will prompt you to enter basic operating information.
Follow this next 6 simple steps:
Language 1/6
English is the default language, please press the SELECT
button to
confirm and move to the next screen.
System Units 2/6
Select ‘metric’ by use of the arrow buttons then press the SELECT
button to confirm and then press SELECT
button again to move to
the next screen.
Current time 3/6
Press the DOWN ( ) or UP ( ) buttons to set the current time.
To rapidly advance, hold the button down continuously. The clock will
be in 24-hour format. Press the SELECT
button to confirm and move
to the nextscreen.
The softener will retain its settings in the event of a short power failure.
Setting Hardness 4/6
Press the UP ( ) or DOWN ( ) buttons to set the value of your water’s
hardness according to the results of your test below. Press the
SELECT
button to confirm and move to the next screen.