EDAN SE-1515 User Manual - page 46
SE-1515 PC ECG User Manual ECG Sampling
- 39 -
4.2.2 Entering Patient Information by Using a Bar Code Reader
The procedure is as follows:
1. Configure the bar code
For more detailed information about configuring the bar code, please contact the
manufacturer or the local distributor.
NOTE: If the two-dimensional bar code reader is used, you should install Symbol
COM Port Emulation Driver manually. For details, please refer to SE-1515 PC
ECG Installation Guide.
2. Connect the USB bar code reader to the computer.
3. Start the SE-1515 PC ECG software.
4. Use the barcode reader to scan the code:
One-dimensional: Place the cursor on the Patient ID in the New Patient window or order
screen and then scan the barcode.
Two-dimensional: On the Archives screen, scan the barcode and the New Patient window
will be displayed with the patient information filled out automatically; or place the cursor on
the patient ID in the New Patient window before scanning.
NOTE:
1. Only the USB bar code
reader
recommended by the manufacturer can be used.
2. The USB bar code
reader
can only read the basic patient information.
4.2.3 Retrieve Patient Information
On the Archives screen, you can use the following two methods to retrieve the information of a
patient recorded before:
Select an order record and click Exam.; or select an examination record, and click Retrieve.
4.3 Selecting the ECG Sampling Type
When creating a new patient record, you can configure the ECG sampling type in the New
Patient window.
When placing a new order, you can select the ECG sampling type in the New Order area.
Options provided are Resting ECG, Exercise ECG, VCG/SAECG, and HRV.