EDAN SONOTRAX Basic User Manual - page 14

SONOTRAX Series Ultrasonic Pocket Doppler User Manual              Doppler and Accessories 

- 9 - 

(2) Charge socket 

: for charging the NI-MH battery pack, the dedicated charger connects 

to the Doppler via this socket. 

(For SONOTRAX II and SONOTRAX II Pro only)

NOTE: 

Accessory equipment connected to the analog and digital interfaces must be certified 

according to the respective IEC/EN standards (e.g. IEC/EN 60950 for data processing 

equipment and IEC/EN 60601-1 for medical equipment). Furthermore all configurations 

shall comply with the valid version of the system standard IEC/EN 60601-1-1. Anybody 

who connects additional equipment to the signal input connector or signal output 

connector to configure a medical system must ensure that the system complies with the 

requirements of the valid version of the system standard IEC/EN 60601-1-1. If in doubt, 

consult our technical service department or your local distributor. 

2.2.5 Probe Socket 

The probe socket is as shown in figure 2-6.   

Figure 2-6 Probe socket

Connect the 2.0MHz/3.0MHz obstetrical probes or 4.0MHz/5.0MHz/8.0MHz vascular probes 

supplied by the manufacturer to the Doppler through the probe socket. 

CAUTION 

1  Do not try to connect any other plug to the probe socket except the plug of the probes 

mentioned above. 

2  Do not stretch the probe cable for more than two meters long. 

Jack Definition 

1 

Power Supply 

2 

Signal 

3 

Probe Coding 1 

4 

Probe Coding 2 

5 

GND 

6 

(Shell) GND