EDAN SONOTRAX Basic User Manual - 3.7 Switching Off
SONOTRAX Series Ultrasonic Pocket Doppler User Manual Examining
- 17 -
3.7 Switching Off
Press the POWER button on the front panel to switch off the Doppler.
For SONOTRAX Basic, SONOTRAX Basic A, SONOTRAX Pro, SONOTRAX II and
SONOTRAX II Pro, it switches off automatically if there is no input signal or no operation is
performed for 60 seconds.
3.8 Replacing/Charging the Battery
3.8.1 Battery Energy Indication
After switched on, the Doppler gives indication of battery energy.
For SONOTRAX Lite and SONOTRAX Vascular, the LED in the bottom left corner of the
display panel lights up in green. When it flashes in orange, the battery power is low.
For SONOTRA Basic, SONOTRAX Basic A, SONOTRAX Pro, SONOTRAX II and
SONOTRAX II Pro, there is a battery symbol in the bottom left corner of LCD. The panes in it
indicate the battery electric energy.
SONOTRA Basic Other Models
The panes disappear gradually with the energy consumption. When the energy is low, the empty
battery symbol flashes and the Doppler gives sharp alarm sounds (NOTE: SONOTRAX Basic
does not give alarm sound). Approximately five minutes later, the Doppler shuts down
automatically.
You should replace the batteries or charge the rechargeable batteries.
3.8.2 Replacing Alkaline Batteries
CAUTION
Make sure the Doppler is shut down before charging the battery or opening the battery
compartment.
When the alkaline batteries are low in energy, they should be removed from the main unit, by
using the procedures described in section 3.2 Installing/Replacing Battery. Dispose of them
according to local regulations.
New alkaline batteries with identical specifications are required. Install them to the Doppler as
introduced in section 3.2.