EMotionLighting EML1205 Instruction Manual - Instructions
EML1205 INS
Rev: Jul 2013
pg. 5/12
Instructions
B. Traffic Light Installation (Decorative Use Only)
1.
Place device close to traffic lights. Unit should not be covered. Unit can be
mounted in an enclosure that is heat tolerant and vented.
2.
Keep away from combustibles. For indoor use only.
3.
Plug the device into a power outlet (120VAC 60Hz.)
4.
Plug in the traffic light as labeled below:
Tip: Select Pattern ‘00’ - All On to test your lights and cords as they are connected.
5.
You can connect multiple signals to the same set of outputs for signals that
face 4 directions.
Tip: Do not exceed 3 amps (360 watts) on a single output or a total of 5 amps
(600 watts) on all outputs.
6.
Once all the lights are connected to the outputs of the device, select one of the
following patterns to test the order:
47 - Traffic Light
48 - Traffic Light Delayed
49 - Traffic Light Digital
50 - Traffic Light Delayed Digital
Direction 1 will start on Red and move to Green.
Direction 2 will start on Yellow and move to Red.
┌──── Direction 1 ────┐ ┌──── Direction 2 ────┐
Red Yellow Green Red Yellow Green