EMotionLighting EML1205 Instruction Manual - Instructions
EML1205 INS
Rev: Jul 2013
pg. 6/12
Instructions
C. Controls
1.
Power Switch / Circuit Breaker
Directs power to controls and outputs. Loads over 5 amps can trip this
breaker and shut down the device.
2.
Display
• Display is active when device is first powered up or after button is
pressed.
• Display shows pattern number by default. Pressing a speed button will
briefly display the speed number before defaulting to pattern number.
• Approximately 1 minute after the last button is pressed, the display
times out (turns itself off) and the pattern and speed settings are saved.
3.
Software Version
Holding both pattern buttons down will display the software version.
4.
Pattern buttons
• Pattern buttons are used to select the pattern number. A description of
the patterns is on page 2.
• Pressing a pattern button will turn the display on. Continuing to press
will increase or decrease the pattern number.
• Every time the pattern is changed the previous speed setting is saved.
5.
Speed buttons
• Pressing a speed button will briefly display the speed number before
reverting to pattern number. Continuing to press will increase or
decrease the speed number.
• A ‘Hi’ or ‘Lo’ will be displayed if the minimum or maximum speed
number is reached.
• Each pattern has its own stored speed setting. This is to say changing
the speed of a given pattern does not change the speed of the other
patterns.
• The speed buttons have a different function for User Defined pattern
numbers 52 - 81. (See Advanced User Defined Programming starting
on page 7.
6.
Medley Modes (Patterns 97-99)
• Medley Mode automatically selects a different pattern to display every
7 minutes according to the order on page 3.
• When Medley Mode selects a pattern, it also selects the saved speed
for that pattern.
• The speed of each pattern can be changed while Medley has the
pattern selected by pressing the speed buttons.