Empire Comfort Systems VFSE-18-1 Owner's Manual - page 17
28092-0-1110
Page 17
GeNerAL NOTeS
Radio Frequency Remote
433.92 MHz for Europe;
315 MHz for U.S. (FCC ID: RTD-G6R) and for Canada (IC:
4943A-G6R).
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired
operation. Changes or modifications not expressly
approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
Batteries - Remote Handset:
1 x 9V block (quality alkaline recommended)
Batteries - Receiver:
4 x 1.5V “AA” (quality alkaline recommended)
An AC Mains Adapter may be used instead of
batteries (only the Mertik Maxitrol or an AC Mains
Adapter approved by Mertik Maxitrol can be used).
NOTe: During a power outage the AC Mains Adapter muts be
unplugged from the receiver to operate in the battery
mode.
AuTOMATIc OPerATION
wArNING
Wiring of valve and receiver must be completed before starting
ignition. Failure to do so could damage the electronics.
NOTe: This remote handset and receiver are not interchange-
able with previous versions.
For all lighting/ignition instructions please refer to
appliance manufacturer’s instructions.
SeTTING THe eLecTrONIcS cODe
Radio Frequency Remote
A code is selected automatically for all Mertik Maxitrol
electronics from among 65,000 random codes available. The
receiver has to learn the code of the handset:
•
Press and hold the receiver’s reset button until you hear two
(2) acoustic signals. After the second, longer acoustic signal,
release the reset button.
•
Within the subsequent 20 seconds press the small flame)
button on the remote handset until you hear an additional long
signal confirming the code is set.
NOTe: This is a one time setting only, and is not required when
changing the batteries in the remote or receiver.
TO TurN ON APPLIANce
wArNING
When pilot ignition is confirmed, motor turns automatically
to maximum flame height.
•
Turn MANUAL knob to the ON, full counterclockwise
position.
•
Place ON/OFF switch (if equipped in (ON position).
G6R-P3TAN5 REMOTE CONTROL INSTRUCTIONS
NOTe: This remote is for use on VFSE Models ONLY.