EYEsurv ESC-Z30 Wiring manual - Introduction:
Introduction:
Thank you for purchasing our EYEsurv ESC-Z30 Zoom Camera. This is a
great surveillance camera that can be used in many different scenarios where a
zoom camera is needed. It has excellent zoom ability and great video quality.
Also, the camera not only lets you zoom from the buttons on the back of the
camera, but also with a PTZ controller or a DVR with PTZ controls. Whichever you
decide to use we here at Nellys Surplus hope this guide will help explain
everything you need to know to get your new camera up and running for your
specific scenario.
Hooking up your ESC-Z30
1.
You will need your ESC-Z30 camera
2. 12VDC Power Supply (1 Amp)
3. A Communication Wire Pair
4. Siamese Cable (Which includes coax video cable and 2 power wires)
5. BNC Connectors to go on the ends of your coax cable.
Step 1
. First off, you will need to decide if you're going to mount your camera
from the top or the bottom, then screw the mounting block into the camera
accordingly. Please note that the camera already comes with the mounting block
on the bottom but this can be changed to the top if you decide.
DO NOT CONNECT THE POWER TO THE POWER SUPPLY UNTIL FULLY WIRED.