EZ-liner Airport Series 1300 Owner's Manual - Bead System
page-27
ez-liner pro series 1300 paint striper - operating manual
page-27
Spray Gun:
3.
Binks Model 570: See Service Section for maintenance and servicing instructions.
a. Periodically disassemble the gun to clean and inspect the parts. Clean thoroughly and replace parts as
needed per manufacturer’s instructions.
b. Put a light layer of grease on the threads of the cap before reassembling
c. If your gun leaks at the tip when you release the trigger, the needle seat is worn or damaged and
must be replace.
Paint Hoses:
4.
Only use high pressure flexible hoses. See parts list for EZLiner P/N
bead system
Bead Gun:
1.
Binks Model 30 Refer to the service section of this manual for complete instructions
and details.
a. The gun should never be operated without having the guard in place.
b. When working on the gun all threads should be clean of glass beads when assembling parts.
c. The needle should always be kept clean.
Bead Tank:
2.
Model PT500RG
Relieve the pressure in the tank by opening the pop off valve before removing the lid from the tank.
For airport applications a special bead tip with a 1/8” hole is available. P/N: 049-0000-03