Fagor AD – 21 W Service Manual - page 13
For Customer Service: Call 1‐866‐GO FAGOR – www.fagorcommercial.com |
P. 13
Warning!
If you require the installation of an NON FAGOR Detergent and Rinse pump, a form MUST be fill out prior to
installation by your installer. Failure to do so will void your Warranty. This form can be located inside your
dishwasher. If lost, please contact Fagor to get a copy.
Note: The detergent pump and rinse dispensing pump will only work during the process of fill and rinse.
PREPARINGTHEWARE
Pre‐scrap and rinse all racks prior to placing them in the dishwasher to remove large food particles
(pre‐ scrap) from the ware.
Wash glassware first
Put trays in the baskets, making sure is in its separate rack (Fig.12).
Put plates in the baskets, making sure each is in its separate rack (Fig. 11).
Put glasses in upside down.
Put cutlery in the cutlery baskets handles down. Mix spoons with knives and forks. (Fig. 10)
Put the special cutlery baskets in the base baskets.
Fig. 10
Fig. 11
DELIMING
In order to maintain dishwasher at optimum conditions, it is requested to remove lime and corrosion
deposits on a frequent basis. A de‐liming solution should be available from your chemical supplier. Read and
follow all instructions on the label of the de‐liming solution. Operations:
Fill the machine. Add the correct amount of de‐liming solutions as recommended by the de‐liming solution
manufacturer. The water capacity of the tank can be verified on the specification sheet of this manual
Remove detergent and rinsing tubes from containers so no chemicals go to the machine
Run the machine for the recommended period of time. As many cycles as needed. Turn off the machine and
open the door. When clean, drain and re‐fill the machine and Run machine for 3‐4 cycles to remove de‐
liming solution
Drain the machine.