Fagor AD – 21 W Service Manual - page 8
For Customer Service: Call 1‐866‐GO FAGOR – www.fagorcommercial.com |
P. 8
ELECTRICALCONNECTION
To access to the electrical connection block (R) (Fig. 1), remove the top cover (T) (Fig. 1) and the rear panel
(P) (Fig. 1). Connect the wires as shown in figure 6. Insert the power cord through the cord holder (E) (Fig. 1)
and make sure to leave enough cable to remove the electrical panel from the front for service. Tighten the
connections.
Leave free 39” ( 1000 mm) of power cord from the rear to facilitate cleaning of the location of the glass‐
washer.
Install a circuit breaker according to required consumption guidelines (Page 1) and data plate.
The machine must be grounded.
Fig. 6
WARNING: Electrical Shock Hazard
It is the personal responsibility and obligation of the customer to contact a qualified electrician to assure
that the electrical installation is adequate and is in conformance with the National Electrical Code, ANSI / NFPA
70 – latest edition and all local codes and ordinance.
BLACK CAP – Red
Wire
BROWN CAP – Red
Wire
BLUE CAP – Red
Wire
BLUE CAP - Red Wire
Neutral
Line
Yellow/
Green
Ground
Terminal Block
(208-220-240V
G