Fakir LINO Instruction Manual - page 23
23
PROBLEM
CAUSE
SOLUTION
Smoke comes out of the
baking compartment or of the
vents
The bread goes down in the
middle and is moist on the
bottom.
It is difficult to take the
bread out of the baking tin.
The ingredients are not mixed
or the bread is not baked
correctly.
The ingredients stick to the
baking compartment or on the
outside of the baking tin
The bread is left too long in the
tin after baking and warming.
The bottom of the loaf is stuck
to the kneading peg.
Incorrect program setting.
The START/STOPP key was
touched while the machine was
working.
The lid opened several timers
while the machine was working.
Pull out the plug and clean the outside
of the baking tin or the baking
compartment.
Take the bread out of the baking tin
before the warming function is over.
Clean the kneading hooks and shaft
after the baking. If necessary, fill the
baking tin with warm water for 30
minutes. Then the kneading pegs can
be easily removed and cleaned.
Check the selected menu and the
other settings.
Do not use the ingredients and start
over again.
The lid is to be opened only if the time
left on the display is more than 1:30
hours (only for programmes „1, 2, 3,
4“). Make sure that lid was closed well
after being opened.
Questions & Answers on Bread Baking Machines
The appliance does not start.
The time acoustic signal goes
off. The display shows E 01.
“EEE” or a similar signal
appears on the display.
Long blackout while the
machine was working.
The rotation of the kneading peg
is blocked.
The appliance is still hot after
the previous baking procedure.
Program or electronic error.
Do not use the ingredients and start
over again.
Check that the kneading peg are
blocked by grains, etc. Pull out the
baking tin and check whether the
drivers turn. If this is not the case,
send the appliance to the customer
service.
Press the START/STOPP button until
the normal programme appears. Pull
out the plug. Take out the baking tin
and leave it to cool at room
temperature. Then insert the plug and
start again.
Start the test run by pulling out the
plug, keeping the menu key pressed
and inserting the plug again.
Release the key. The menu performs
a test run. Unplug again and then plug
in again. The normal program should
appear on the display. If this is not
the case, send the appliance to the
Customer Service.