Fakir PANE DELUXE Instruction Manua - page 20
20
Problem
Cause
Solution
Smoke comes out of the
baking compartment or of
the vents
The ingredients stick to the baking
compartment or on the outside
of the baking tin
Pull out the plug and clean the
outside of the baking tin or the
baking compartment.
The bread goes down in the
middle and is moist on the bottom.
The bread is left too long in the
tin after baking and warming.
Take the bread out off the baking
tin before the warming function
is over.
It is difficult to take the bread out
of the baking tin.
The bottom of the total is stuck
to the kneading peg.
Clean the kneading peg and shaft
after the baking. If necessary, fill
the baking tin with warm water
for 30 minutes. Then the
kneading pegs can be easily
removed and cleaned.
The ingredients are not mixed or
the bread is not baked correctly.
Long blackout while the machine
was working.
Check the selected menu and the
other settings.
Incorrect program setting.
The START/STOP key was
touched while the machine was
working.
The lid opened several timers
while the machine was working.
The rotation of the kneading peg
is blocked.
The appliance does not start. The
time acoustic signal goes off. The
display shows E 01.
The appliance is stil hot after the
previous baking procedure.
Press the START/STOP button
until the normal programme
appears. Pull out the plug. Take
out the baking tin and leave it
to cool at room tempeature.
Then insert the plug and start
again.
“EEE” or a similar ssignal appears
on the display.
Program or electronic error.
Start the test run by pulling out
the plug, keeping the menu
key pressed and inserting the
plug again. Release the key.
The menu performs a test run.
Unplug again The normal
program should appear on the
display. If this is not the case,
send the appliance to the
Customer Service.
Questions & Answers On Bread Baking Machines
The lid is to be opened only if
the time left on the display is
more than 1:30 hours (only for
proggrammes “1,2,3,4”) Make
sure that lid was closed well
after being opened.
Do not use the ingredients and
start over again.
Do not use the ingredients and
start over again.
Check that the kneading pegs
are blocked by grains,etc. Pull
out the baking tin and check
whether the drivers turn. If this
is not the case,send the
appliance to the customer
service.