Falcon 1092 Deluxe Dual Fuel User's Manual & Installation And Servicing Instructions - Electrical  Connection

24

c)  Mark off 300mm from the RH side of the unit to 

indicate the centre line for the bracket.

d)  Remove the unit.

e)  Mark off 595mm to locate the front edge of the lower 

bracket. Fix bracket to floor.

f)  Measure the height from floor level to the top edge 

of the rear channel. Add 3mm to this dimension and 

assemble the stability bracket to this height (i.e. from 

floor level to underside of top member).

Gas Connection

The Gas supply needs to terminate with a down facing 

bayonet. The rear cover boxes limit the position of the 

supply point.

view from the rear

A 

position for gas supply connector

B 

appliance gas inlet

Because the height of the cooker can be adjusted and 

each connection is different it is difficult to give precise 

dimensions. Ideally the house supply bayonet should 

be in the shaded area shown in the diagram. Although 

a 900mm hose can be used, a 1250mm hose will allow 

slightly more flexibility in the positioning of the bayonet 

and make moving the cooker easier. The hose should 

be fitted so that both inlet and outlet connections are 

vertical so that the hose hangs downwards.

The hose should be fitted so that both inlet and 

outlet connections are vertical so that the hose hangs 

downwards in a ‘U’ shape.

For Natural Gas the flexible hose must be in accordance 

with B.S.669. 

For LP Gas it should be capable of 50mbar pressure, 70C 

temperature rise and carry a red stripe, band or label.

If in doubt contact, your supplier. 

Screw connect the threaded end of the hose into the gas 

inlet in the underside of the connector block on the back 

of the cooker.  

After completing the gas connection, check the cooker 

is gas sound with a pressure test. When checking for gas 

leaks do not use washing up liquid - this can corrode. 

Use a product specifically manufactured for leak 

detection.

Pressure testing

The gas pressure can be measured at the pressure test 

point on the gas connection block. Turn and light one of 

the hotplate burners.

For Natural Gas the pressure should be 20mbar.

For Propane the pressure should be 37mbar.

Reassemble burner top, making sure it is reassembled in 

the correct way on the burner body.

Electrical  Connection

This appliance must be installed by a qualified electrician 

to comply with the relevant regulations and also the 

local electricity supply company requirements.

WARNING: THIS APPLIANCE MUST BE EARTHED

Note

The cooker must be connected to the correct electrical 

supply as stated on the voltage label on the cooker, 

through a suitable cooker control unit incorporating 

a double pole switch having a contact separation 

of at least 3mm in all poles. This cooker must not be 

connected to an ordinary domestic power point.

The total electrical load of the appliance is approximately 

7.2kW. The cable size used should be suitable for this 

load and comply with all local requirements.

Access to the mains terminal is gained by removing the 

electrical terminal cover box on the back panel.

Connect the mains cable to the correct terminals for your 

electrical supply type.

Check that the links are correctly fitted and 

that the terminal screws are tight.

Secure the mains cable using the cable clamp.