Falcon 1092 Deluxe Dual Fuel User's Manual & Installation And Servicing Instructions - Hotplate
25
Hotplate
Check each burner in turn. There is a flame safety device
that stops the flow of gas to the burner if the flame goes
out. There is also a spark ignition system that works
when the knob is pressed in.
For each burner, push in and turn the knob to the large
flame symbol ( ).
The igniter should spark and light the gas. Keep holding
the knob pressed in to let the gas through to the burner
for few seconds.
If, when you let go of the control knob, the burner goes
out, the safety device has not held in. Turn the control to
the off position and wait one minute, then try again this
time holding in the control knob for slightly longer.
Grill
Open the grill compartment door. Turn on the grill
control and check that the grill heats up.
Oven check
Turn on the ovens and check that they start to heat up.
Turn off the ovens.
Fitting the plinth
Loosen the 3 screws along the front bottom edge of the
cooker. Hook the central keyhole over the central screw.
Twist and fit each end keyhole over their respective
screws. Tighten the fixing screws.
Refit the drawer
Rest the drawer back on the side runners and, keeping
it level, push it right back. The clips should click into
position holding the drawer to the side runners.
Leave the levelling tool in the storage drawer, so that the
customer can use it if they wish to move the cooker.
Door adjustment
Please check the aligment of the doors. The oven doors
have adjustible hinges.
To Adjust the Oven Door Angle
The door bottom hinge can be adjusted to alter the
angle of the door.
Loosen the bottom hinge fixing screws and use the
notch and a flat bladed screwdriver to move the position
of the hinge to set the hinge position.
Retighten the hinge screws.
Effect of hinge adjustment – exaggerated for clarity
Centre line of hinge pin
Oven door omitted for clarity
Customer care
Please inform the user how to operate the cooker and
hand over these instructions.
Thank you.