Falcon 1092 Deluxe Dual Fuel User's Manual & Installation And Servicing Instructions - Servicing  -  Warning

SERVICING  - WARNING 

Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished. 

26

Conversion to LP Gas

Servicing  -  warning

This conversion must be performed by a competent 

person. After conversion the installation must comply 

with the relevant regulations and also the local 

electricity supply company requirements. Read the 

instructions before converting this appliance.

Failure to convert the appliance correctly could 

invalidate any warranty or liability claims and lead to 

prosecution.

This instruction must be used in conjunction with 

the rest of the appliance instruction, in particular 

for information on Standards, cooker positioning, 

connection hose suitability etc.

When servicing or replacing gas-carrying components 

disconnect from gas before commencing operation and 

check appliance is gas sound after completion.

Do not use re-conditioned or unauthorised gas controls.

Conversion

Disconnect from electricity and gas before servicing. 

Check appliance is safe when you have finished.

This appliance is CAT II 2H3+. It is supplied set for G20 

natural gas at 20millibar

A conversion kit for LP gas is supplied with the cooker.

Injectors

Remove pan supports and burner heads. 

Undo the large brass nuts and remove the brass venturis 

and brass rings.

Either:-

Use a long box spanner to access and remove the 

old jets.

Or: -

Lift up the front of the hotplate top and prop it 

up. The burner bases are now accessible - remove 

the old jets.

Save the jets removed from the appliance for possible 

future use. Fit the new jets, see the table  for the correct 

type.

If you have lifted up the hotplate then carefully replace 

it taking care not to damage or displace the ignition 

electrodes or flame safety probes (arrowed) and 

replace the rear fixing screws.

To  convert  the  control  taps

Pull off all the control knobs.

Open the oven door & grill door and remove the fixing 

screws underneath the control panel.

Remove the 3 fixing screws at the top of the control 

panel.

Pull the control panel forward. Rest it on the open grill 

door and the open right hand oven door

The tap bypass screw is now accessible. Unscrew the tap 

bypass screw. 

Using a pair of long nose pliers carefully remove the 

bypass screw and fit the correct replacement screw. See 

table for correct size. Tighten the screw down.

Repeat for all the burner control taps.

Refi t the control panel. 

ArtNo.0102-0001 - Unscrewing

the control valve bypass screw

ArtNo.0102-0002 - Removing the

tap bypass screw