Falcon Elan U109645 - 02 Installation & service instructions manual - page 14
U109645 14
Australia
Oven Shelves
Drop shelves are supplied in addition to the flat shelf,
thereby increasing the spacing possibilities:
The shelf guard should be at the back pointing upwards
You can easily remove and refit a shelf, as follows:
Pull the shelf forward until the back of the shelf is stopped
by the shelf stop bumps in the oven sides:
Lift up the front of the shelf so the back of the shelf will
pass under the shelf stop and then pull the shelf forward:
To refit the shelf, line up the shelf with a groove in the
oven side and push the shelf back until the ends hit the
shelf stop. Lift up the front so the shelf ends clear the shelf
stops, and then lower the front so that the shelf is level,
and push it fully back.
The Handyrack (Main Oven)
The maximum weight that can be held by the Handyrack
is 5.5kg (12lb). It should only be used with the supplied
roasting tin, which is designed to fit the Handyrack. Any
other vessel could be unstable.
Additional roasting tins are available from our cookware
collection - Part Code RM027.
The Handyrack fits inside the left hand main oven door.
The food cooking on it is easy to attend to because it’s
immediately accessible when the door is opened.
It can be fitted at two different heights. One of the oven
shelves must be removed and the other positioned to suit.
When the Handyrack is used in its higher position, other
dishes can be cooked on the bottom shelf position of the
oven or by placing a shelf directly on the base of the oven.
When the Handyrack is used in its lower position, other
dishes can be cooked directly on the base of the oven.
To fit the Handyrack, locate one side of it on the door
bracket:
Then spring the other side out to clip it onto the other
bracket.