Falcon Elan U109645 - 02 Installation & service instructions manual - page 20
U109645 20
INSTALLATION
Check that the appliance is electrically safe when you have finished.
Australia
You will need the following items to complete the cooker
installation satisfactorily:
•
Multimeter
(for electrical checks)
•
Cooker levelling tool with Allen keys
(provided in pack)
You will also need the following tools:
1.
Electric drill
2. Masonry drill bit (only required if fitting the cooker on a
stone or concrete floor)
3. Rawlplugs (only required if fitting the cooker on a stone or
concrete floor)
4. Steel tape measure
5. Cross-head screwdriver
6. Flat-bladed screwdriver
7. Spirit level
8. Pencil
9. Adjustable spanner
Checking the parts (other than the levelling tool and Allen
keys shown above)
One flat oven shelf and three
drop shelves
One large handle and four small
handles
Handyrack
Roasting tin
Grill pan and trivet
Splashback and Plinth
Positioning the Cooker
The diagrams below show the minimum recommended
distance from the cooker to nearby surfaces.
The hob should be level with, or above, any adjacent work
surface. Above hob level, a gap of 75mm should be left
between each side of the cooker and any adjacent vertical
surface.
For non-combustible surfaces (such as unpainted metal or
ceramic tiles) this can be reduced to 25mm.
A minimum space of 650mm is required between the top
of the hob and a horizontal combustible surface.
The following diagram shows suggested clearances above
the cooker:
* Any cooker hood should be installed in accordance
with the hood manufacturer’s instructions.
Surfaces of furniture and walls at the sides and rear of
the appliance should be heat, splash and steam resistant.
Certain types of vinyl or laminate kitchen furniture are
particularly prone to heat damage and discolouration.
We cannot accept responsibility for damage caused
by normal use of the cooker to any material that de-
laminates or discolours at temperatures less than 65°C
above room temperature.
For safety reasons, curtains must not be fitted
immediately behind the cooker.
We recommend a gap of 1110mm between units to
allow for moving the cooker. Do not box the cooker in; it
must still be possible to move the cooker in and out for